Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 732

SYSMGR Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
Recommended Action
Error Message
during switchover - hasn't caught signal [dec] .
Explanation
Recommended Action
Error Message
its switchover actions (error-id [hex]).
Explanation
Recommended Action
Error Message
terminated during switchover with error code [dec] .
Explanation
Recommended Action
Error Message
exceeded ([dec] switchovers happened within [dec] seconds). Powering down all
linecards.
Explanation
Recommended Action
Error Message
respond to switchover message in [dec] seconds
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
response swover message in [dec] seconds
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Cisco NX-OS System Messages Reference
2-694
SYSMGR-2-SWITCHOVER_OVER: Switchover completed.
The switchover is completed.
No action is required.
SYSMGR-2-SWITCHOVER_SRVCRASHED: Service [chars] (PID [dec]) crashed
The switchover failed because a service crashed during switchover.
No action is required.
SYSMGR-2-SWITCHOVER_SRVFAILED: Service [chars] failed in performing
The switchover failed because a service could not transition to the active state.
No action is required.
SYSMGR-2-SWITCHOVER_SRVTERMINATED: Service [chars] (PID [dec])
The switchover failed because a service terminated during switchover.
No action is required.
SYSMGR-2-SWITCHOVER_THRESHOLD_EXCEEDED: Switchover threshold
Switchover threshold exceeded.
No action is required.
SYSMGR-2-SWITCHOVER_TIMEOUT: Service [chars] (vdc [dec]) did not
The switchover timeout because a service failed to response.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-SWITCHOVER_TIMEOUT: Service [chars] (vdc [dec]) does not
The switchover timeout because a service failed to response.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Chapter 2 System Messages and Recovery Procedures
OL-15994-03