Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 555

Nx-os system messages reference
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

Chapter 2
System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
port removed)
Explanation
Recommended Action
entity is removed. This happens normally due to the module on which the src interface exists is
removed.
Error Message
Explanation
bringing it up.
Recommended Action
terminal', 'interface [char]', 'shutdown', 'no shutdown' on the interface. If this happens again obtain
output of 'show port internal all interface [char]' on the interface.
Error Message
(Suspended due to incompatible mode)
Explanation
different from that of the port channel.
Recommended Action
check to ensure that the remote end of the interface also belongs to the same port channel.
Error Message
(Suspended due to incompatible speed)
Explanation
different from that of the port channel.
Recommended Action
remote end of the interface also belongs to the same port channel.
Error Message
due to incompatible remote switch WWN)
Explanation
different from that of the port channel.
Recommended Action
other interfaces in the port channel.
OL-15994-03
PORT-5-IF_DOWN_SRC_PORT_REMOVED: Interface [chars] is down(Tunnel src
Tunnel source port of this FCIP interface has been removed.
The src interface with ip address that matches the ip address of the bound
PORT-5-IF_DOWN_SUSPENDED: Interface [chars] is down (Suspended)
This interface belongs to a port channel and has been suspended to an error while
In most cases, you can recover using the following commands 'config
PORT-5-IF_DOWN_SUSPENDED_BY_MODE: Interface [chars] is down
This interface belongs to a port channel and operational mode of the interface is
Change the mode and the trunking mode of the port channel from 'auto' and
PORT-5-IF_DOWN_SUSPENDED_BY_SPEED: Interface [chars] is down
This interface belongs to a port channel and operational speed of the interface is
Change the speed of the port channel from 'auto' and check to ensure that the
PORT-5-IF_DOWN_SUSPENDED_BY_WWN: Interface [chars] is down (Suspended
This interface belongs to a port channel and remote switch WWN of the interface is
Ensure that this interface is connected to the same remote switch as all the
Cisco NX-OS System Messages Reference
PORT Messages
2-517

Advertisement

Table of Contents
loading

Table of Contents