Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 807

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
error.
Recommended Action
Error Message
message on %s queue with opcode %d, dropping it
Explanation
Recommended Action
Error Message
client %s: %d (should be %d)
Explanation
dropped.
Recommended Action
Error Message
Explanation
Parameters: MTS queue name, Error ...
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
resolve buffer
Explanation
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
%s%%%s, client \%s\
Explanation
Parameters: Prefix, Prefix Length, Next-hop, Interface, Client ...
Recommended Action
OL-15994-03
URIB-3-MTS_REGISTER Format: mts_register failed for urib: %s
URIB was unable to register client for URIB notifications, causing an unrecoverable
Use the 'restart' command to restart the feature and clear this problem.
URIB-3-MTS_SHORT_MSG_ERROR Format: Received short (%d < %d) MTS
URIB received an unknown message. The message is dropped.
No action is required.
URIB-3-MTS_SIZE_ERROR Format: %s: incorrect %s message size from
The size of a URIB message is incorrect for the type of message. The message is
No action is required.
URIB-3-MTS_UBIND Format: mts_unbind failed for %s: %s
URIB was unable to unbind from an MTS queue SAP, causing an unrecoverable error.
Use the 'system switchover' command to switch over to the standby supervisor.
URIB-3-NH_RESOLV_ADD_ERROR Format: Could not add %s/%d to the %s (%d)
A error was encountered. The system may run into more errors because of this problem.
Use the 'system switchover' command to switch over to the standby supervisor.
URIB-3-NHLFE_DEL_ERROR Format: Could not find nhlfe for %s/%d via
Next-hop had a NHLFE, but could not delete it while deleting the Next-hop.
No action is required.
Cisco NX-OS System Messages Reference
URIB Messages
2-769