Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 741

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
failed(error-id [hex]).
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
failed(error-id [hex]).
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
current running-config on standby supervisor.
Explanation
redundancy mode is still set to HA.
Recommended Action
Error Message
reset (error-id [hex]).
Explanation
switchover to fail.
Recommended Action
Error Message
failed in non-disruptive upgrade recovery (error-id [hex]).
Explanation
Recommended Action
OL-15994-03
SYSMGR-3-LC_SAVE_STATES_FAILURE: Save states request for the linecard
Save state request for the line card failed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-3-LC_STOP_ASYNC_FAILURE: Stop async notification request
Stop asynchronizationnotification request for the line card failed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-3-LC_UPG_ERROR: LC ERROR: [chars]
Linecard upgrade error message.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-3-MISSING_OPTIONAL_CAPABILITY: Incomplete support for the
Loose config incompatibilities exist between active and standby sup. Operational
No action is required.
SYSMGR-3-MODULE_LOCK_FAILED: Failed to lock the local module to avoid
Locking the local module has failed. Reloading the local module can now result in
No action is required.
SYSMGR-3-ND_UPGD_RECOVERY_SRVFAILED: Service [chars] in vdc [dec]
The nondisruptive upgrade failed because a service could not recover its state.
No action is required.
Cisco NX-OS System Messages Reference
SYSMGR Messages
2-703