Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 805

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
unicast internal event-history errors' command for more information.
Parameters: Owner, Routes, RNHs ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
instance info for client \%s\, VRF %s
Explanation
further errors to indicate the failure in more detail. The shown VRF should be reconfigured in the
client. i.e. in router sub-mode configuration, 'no vrf <vrf-name>'
Parameters: Client, VRF ...
Recommended Action
Error Message
Explanation
because of this problem.
Recommended Action
Error Message
Explanation
depending on the previous error logged.
Parameters: Client, Message ...
Recommended Action
Error Message
Explanation
taken depending on the previous MTS error logged.
Recommended Action
Error Message
Explanation
Parameters: MTS queue name, Error ...
Recommended Action
all VDCs on the system.
OL-15994-03
URIB-3-INCONSISTENT_SUMMARY Format: %s: routes %d, rnh's %d
Unexpected remaining state for client during RIB cleanup. Use the 'show routing ipv4
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
URIB-3-INSTANCE_CREATE_ERROR Format: Failed to create routing
URIB could not create its data structures for a client in the shown VRF. There may be
Requires operator to intervene.
URIB-3-KSINK_LIB_ERROR Format: %s %s
A error was encountered during ksink operations. The system may run into more errors
No action is required.
URIB-3-MORE_INFO_ERROR Format: Client \%s\: %s
This error provides further information about the previous error. Action should be taken
No action is required.
URIB-3-MORE_MTS_INFO_ERROR Format: source SAP is: %d dest SAP is: %d
This error provides further information about the previous MTS error. Action should be
No action is required.
URIB-3-MTS_BIND Format: mts_bind failed for %s: %s
URIB was unable to bind to an MTS queue SAP, causing an unrecoverable error.
Use 'reload' command to reload the system. Be aware that this problem affects
Cisco NX-OS System Messages Reference
URIB Messages
2-767