Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 675

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
SS_EID_VL_ER_MDISK_ACCESS_INVALID ) Access beyond end of disk, or Managed Disk
missing [chars]
Explanation
the cluster, or in a disk enclosure or disk controller that is connected to the node.
Recommended Action
controllers. 2. Run a configuration dump and a logged data dump. Save the dump data. 3. Contact
the Cisco Technical Assistance Center (TAC) through the Cisco Support web site
http://www.cisco.com/tac. 4. Mark the error you have just repaired as fixed.
Error Message
SS_EID_VL_ER_MDISK_DEVICE_PORT_EXCLUDED ) Remote Port excluded for a specific
Managed Disk and Node [chars]
Explanation
Recommended Action
Using the mdisk ID, determine the failing disk controller. 3. Refer to the service documentation for
the disk enclosure or disk controller and the fibre-channel network fabric to resolve the reported
problem. 4. Start a cluster discovery operation to recover the excluded fibre-channel port. 5. Include
the managed disk that you noted in step 1. 6. Check the status of the disk controller. If all disk
controllers show a good status, mark the error you have just repaired as fixed. 7. If all disk
controllers do not show a good status, contact the Cisco Technical Assistance Center (TAC) through
the Cisco Support web site http://www.cisco.com/tac. to resolve the problem with the disk
controller.
Error Message
Managed Disk excluded due to excessive errors, or all device ports excluded [chars]
Explanation
excessive errors or unusual behavior.
Recommended Action
If any managed disks show a status of online, mark the error you have just repaired as fixed. If all
managed disks show a status of excluded, include the managed disks and then mark the error as
fixed.
Error Message
SS_EID_VL_ER_MDISK_INITIALISE_INVALID ) Invalid blocksize, capacity or LUN
identity has changed during Managed Disk initialisation [chars]
Explanation
Recommended Action
Include the managed disk into the cluster. 3. Check the managed disk status. If all managed disks
show a status of online, mark the error you have just repaired as fixed. 4. If not all managed disks
show a status of online, check the status of the disk controller.
OL-15994-03
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
The error that is logged in the cluster error log indicates a software problem either in
1. Ensure that the software is at the latest level on the cluster and on the disk
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
A remote fibre-channel port has been excluded.
1. View the error log. Note the mdisk ID associated with the error code. 2.
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_MDISK_EXCLUDED )
A managed disk or managed disk controller port has been excluded because of
1. Repair the enclosure or disk controller. 2. Check the managed disk status.
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
Access beyond end of disk. The initialization of the managed disk has failed.
1. Check the status of the managed disk and of the managed-disk group. 2.
Cisco NX-OS System Messages Reference
SVC Messages
2-637