Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 717

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
(pre-start phase).
Explanation
Recommended Action
reset-reason' to know what caused the switchover.
Error Message
Explanation
Recommended Action
reset-reason' to know what caused the switchover.
Error Message
[chars] ([dec])
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
setting heartbeat for last [dec] periods.
Explanation
service and if this service has restartability set to TRUE, the service will restart.
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
ISSU reboot, errno: [dec].
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
service [chars]. Expected [dec].
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
OL-15994-03
SYSMGR-2-HASWITCHOVER_PRE_START: This supervisor is becoming active
A cold switchover has started (pre-start phase).
When the other supervisor is back online, use the command 'show system
SYSMGR-2-HASWITCHOVER_START: This supervisor is becoming active.
A cold switchover has started.
When the other supervisor is back online, use the command 'show system
SYSMGR-2-HEARTBEAT_FAILED: Sysmgr heartbeat failed at %lu. [chars].
The system manager had failure while trying to heartbeat with KLM.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-HEARTBEAT_FAILURE: Service [chars] sent SIGABRT for not
A service is not setting proper heartbeats to The system Manager So it will kill this
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-INBAND_START_FAILED: Failure while bringing up inband after
Sysmgr tried to bring up inband after ISSU reboot, but the call has detected an error.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-INVALID_HANDSHAKE: Invalid secret ([dec]) received from
A service cannot be started.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Cisco NX-OS System Messages Reference
SYSMGR Messages
2-679