Npv-3 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

NPV Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
[chars] describes the error and its context.
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Cisco NX-OS System Messages Reference
2-418
NPV-3-F_RJT_SENT: [chars]
NPV process sent an F_RJT frame.
No action is required.
NPV-3-FC2_SEND_FAILED: [chars]
NPV process could not send an FC2 message.
No action is required.
NPV-3-INTERNAL_ERROR: Internal error: [chars]
NPV process encountered a generalerror thatdoes not fall in any of the categories.
No action is required.
NPV-3-LCP_PROGRAMMING_FAILED: [chars]
LCP programming request initiated by the NPV process has failed.
No action is required.
NPV-3-LOCK_FAILED: [chars]
An error has occurred while acquiring the lock. The reason for the failure : [chars].
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
NPV-3-LS_RJT_RCVD: [chars]
NPV process received an LS_RJT frame.
No action is required.
NPV-3-LS_RJT_SENT: [chars]
NPV process sent an LS_RJT frame.
No action is required.
NPV-3-MALLOC_FAILED: [chars]
NPV process could not allocate enough memory.
No action is required.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03