Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 792

U6RIB Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
examined for the cause.
Parameters: Failed API, Error Code, Error Description, u6RIB Function ...
Recommended Action
all VDCs on the system.
Error Message
code %d
Explanation
because of this problem.
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
Explanation
of this problem.
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
Explanation
of this problem.
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' CLI command.
Error Message
(0x%08x)
Explanation
Parameters: Range, Provider of value, Value Provided ...
Recommended Action
Support web site http://www.cisco.com/tac.
Cisco NX-OS System Messages Reference
2-754
U6RIB-3-PSS Format: Error returned from %s, errno: 0x%08x (%s) in %s()
U6RIB called a PSS API which returned an error. The error reported should be
Use 'reload' command to reload the system. Be aware that this problem affects
U6RIB-3-PTADD_ERROR Format: Could not add %s/%d to the %s pt, error
A severe route table error was encountered. The system may run into more errors
Use the 'system switchover' command to switch over to the standby supervisor.
U6RIB-3-QADD_ERROR Format: Could not add %s to the %s queue
A severe queue error was encountered. The system may run into more errors because
Use the 'system switchover' command to switch over to the standby supervisor.
U6RIB-3-QDEL_ERROR Format: Could not delete %s from the %s queue
A severe queue error was encountered. The system may run into more errors because
Use the 'system switchover' command to switch over to the standby supervisor.
U6RIB-3-RANGE_CHECK_ERR Format: Range check of %s failed from %s
The value provided is outside of the acceptable range.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Chapter 2 System Messages and Recovery Procedures
OL-15994-03