Scsi-Target Messages; Scsi-Target-2 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m

SCSI-TARGET Messages

This section contains the SCSI-TARGET messages.

SCSI-TARGET-2

Error Message
SCSI-target driver error: [hex]
Error Message
SCSI-target driver error: [hex]
Error Message
SCSI-target driver error: [hex]
Error Message
pwwn from WWN Manager error: [hex] response: [hex]
Error Message
[hex]
OL-15994-03
SCSI-TARGET-2-PROC_ADD_NPORT_FAIL: Failed to set local nport with
Explanation SCSI-target process add nport with its peer kernel driver [hex]. No SCSI discovery can
be performed.
Collect more information using the command 'show scsi-target internal driver'.
Recommended Action
SCSI-TARGET-2-PROC_OPEN_VHBA_DEVICE_FAIL: Failed to communicate with
Explanation SCSI-target process failed to communicate with its peer kernel driver [hex]. No SCSI
discovery can be performed.
Collect more information using the command 'show scsi-target internal driver'.
Recommended Action
SCSI-TARGET-2-PROC_SET_SCSI_INDEX_FAIL: Failed to set SCSI index
SCSI-target process failed to set SCSI index with its peer kernel driver [hex]. No SCSI
Explanation
discovery can be performed.
Collect more information using the command 'show scsi-target internal driver'.
Recommended Action
SCSI-TARGET-2-PROC_WWNM_GET_WWN_FAIL: Failed to get local controller
SCSI-target process used wwnm_bwt_get_local_controller_wwn() API for the port
Explanation
wwn and it failed due to error [hex], response code [hex]. No SCSI discovery can be performed.
Collect more information using the commands 'show process cpu' and 'show
Recommended Action
system internal sysmgr service all'. See WWN Manager system error codes for reason.
SCSI-TARGET-2-PSS_INIT_FAIL: pss initialization failed due to error:
SCSI-target process pss initialization failure due to error [hex]. No SCSI discovery can
Explanation
be performed.
Collect more information by using the show flash command. See the pss
Recommended Action
system error codes for the information about the failure.
SCSI-TARGET Messages
Cisco NX-OS System Messages Reference
2-587