Pim6-5 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
PIM6-6
Error Message
Error Message
use shared tree config is %d
Error Message
supported
Error Message
Error Message
Error Message
negative-bit set, ignore group entry
OL-15994-03
PIM6-6-IF_DEPEND Format: Removed interface (%s) has %s dependency
There is residual configuration on the deleted interface.
Explanation
Parameters: Interface name, Dependent Config Command ...
No action is required.
Recommended Action
PIM6-6-MAX_GRANGES Format: Max Granges allowed to be configured for
Exceeded the group range limit.
Explanation
Recommended Action No action is required.
PIM6-6-MAX_RPS Format: Cannot store bidir-RP %s, a maximum of %d are
Due to hardware limitations, there is a maximum number of Bidir-PIM6 RPs that can
Explanation
be stored.
Recommended Action No action is required.
PIM6-6-MQFLUSHED Format: Flushing %lu messages from %s mq
Flushing old residual messages fom the message-queue.
Explanation
No action is required.
Recommended Action
PIM6-6-MQLOOP_UNKNOWN_MSG Format: Received unknown message %d/%d
Explanation PIM6 process received unknown Interprocess message, dropped.
No action is required.
Recommended Action
PIM6-6-NEGATIVE_PREFIX Format: Group prefix %s/%d from RP %s has
The RP is advertising a group range to be in dense-mode. This implementation only
Explanation
supports sparse-mode so the group entry will be igored.
Parameters: Type of malloc(size), Function Name ...
No action is required.
Recommended Action
Cisco NX-OS System Messages Reference
PIM6 Messages
2-469