Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 809

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
error code %d
Explanation
because of this problem.
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
Explanation
of this problem.
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
(0x%08x)
Explanation
Parameters: Range, Provider of value, Value Provided ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
exceeds %d\n Flagging route %s/%d from client \%s\ with nh %s, rnh %s/%d\n as
causing rnh loop
Explanation
client caused the loop.
Parameters: Max RNH Loop, Prefix, Prefix Length, Client, Next-hop, Prefix, Prefix Length ...
Recommended Action
Error Message
Explanation
Parameters: Function, RPM Error Code ...
Recommended Action
OL-15994-03
URIB-3-PTDEL_ERROR Format: Could not delete %s/%d from the URIB pt,
A severe route table error was encountered. The system may run into more errors
Use the 'system switchover' command to switch over to the standby supervisor.
URIB-3-QADD_ERROR Format: Could not add %s to the %s queue
A severe queue error was encountered. The system may run into more errors because
Use the 'system switchover' command to switch over to the standby supervisor.
URIB-3-RANGE_CHECK_ERR Format: Range check of %s failed from %s
The value provided is outside of the acceptable range.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
URIB-3-RNH_LOOP_ERROR Format: Number of prefixes forming rnh loop
URIB detected a loop between routes installed in the RIB. The message shows which
Requires operator to intervene.
URIB-3-RPM_LIB_ERROR Format: %s %d
An RPM library function returned an error.
No action is required.
Cisco NX-OS System Messages Reference
URIB Messages
2-771