Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 85

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
BGP-3
Error Message
Error Message
Error Message
Error Message
Error Message
opcode %d, address %s, ignore it
OL-15994-03
BGP-3-ACLTESTADD Format: Failed to add %s peer policy test
An internal software error occurred.
Explanation
Parameters: ACL type ...
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
BGP-3-AGGADD Format: [%s] Couldn't add aggregate for %s/%d
BGP was unable to store an aggregate in an internal datastructure. The BGP process
Explanation
may have run out of memory.
If BGP ran out of memory, add memory to the router or change the network
Recommended Action
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
BGP-3-AGGDEL Format: [%s] Couldn't delete aggregate for %s/%d
An unexpected but recoverable event has occurred.
Explanation
Parameters: Address-family, Prefix/masklength ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
BGP-3-ALLOCFAIL Format: %s malloc (%ld) failed for: %s
The system may be low on memory.
Explanation
Parameters: Alloc Type, Size, Error ...
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
BGP-3-API_UNEXP_RESP Format: Received unexpected message from SAP %d,
An unexpected but recoverable event has occurred.
Explanation
Parameters: MTS SAP, MTS Opcode, IP Address ...
No action is required.
Recommended Action
Cisco NX-OS System Messages Reference
BGP Messages
2-47