Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 718

SYSMGR Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
[chars]: [chars] (error-id [hex]).
Explanation
system cannot proceed further.
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
declares itself in the same state as this System Manager ([chars]).
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Recommended Action
Error Message
[chars].
Explanation
Recommended Action
Error Message
to standby causing standby to reset.
Explanation
to standby.
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
with [chars] (errno [dec])
Explanation
affect HA.
Recommended Action
Support web site http://www.cisco.com/tac.
Cisco NX-OS System Messages Reference
2-680
SYSMGR-2-INVALID_SYSMGRCONF: [chars]: invalid configuration file
The system image contains an inconsistent list of services. The initialization of the
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-INVALID_VERSIONMSG: The remote System Manager ([chars])
The redundancy state negotiation between the two supervisors failed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-ISSU_FAILED: The ISSU has failed: [chars] (error-id [hex])
The ISSU has failed and the switch need to be rebooted.
No action is required.
SYSMGR-2-LAST_CORE_BASIC_TRACE: [chars]: PID [dec] with message
The system has detected an error.
No action is required.
SYSMGR-2-MSG_SEND_FAILURE_STANDBY_RESET: Failure in sending message
The system is resetting the standby since mts on the active is unable to send a message
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-MTS_FLUSH_SYNC_QUEUE_FAILURE: flush mts sync queue failed
Calling mts_flush_sync_queue to guarante no outstanding messages. the failure might
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Chapter 2 System Messages and Recovery Procedures
OL-15994-03