Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 92

BGP Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
Parameters: MTS SAP, MTS Opcode, Error ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Parameters: Peer address, Error ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
%s/%d, error %d
Explanation
out of memory.
Parameters: Address-family, Prefix/masklength, Error ...
Recommended Action
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message
%s/%d, error %d
Explanation
Parameters: Address-family, Prefix/masklength, Error ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Parameters: Address-family, Msg Type, Peer address ...
Recommended Action
Support web site http://www.cisco.com/tac.
Cisco NX-OS System Messages Reference
2-54
BGP-3-MTSSEND Format: MTS send() error to SAP %d, opcode %d: %s
An unexpected but recoverable event has occurred.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-NBRERR Format: %s Peer error: %s
An internal software error occurred.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-NEGWRITE Format: Negative nr of %d bytes left to write to peer %s
An internal software error occurred.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-NEXTHOPADD Format: [%s] Couldn't add next-hop to RNHDB for
The router was unable to store a BGP next hop in an internal database, because it ran
If BGP ran out of memory, add memory to the router or change the network
BGP-3-NEXTHOPDEL Format: [%s] Couldn't delete next-hop from RNHDB for
An unexpected but recoverable event has occurred.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-NOBUF Format: [%s] Unable to get buffer for %s msg to peer %s
An internal software error occurred.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Chapter 2 System Messages and Recovery Procedures
OL-15994-03