Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 715

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
configuration.
Explanation
was trying to zip the converted configuration.
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Recommended Action
Error Message
failed with return value: ([dec]).
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
config failed during boot (error-id [hex]).
Explanation
during boot.
Recommended Action
initialize the configuration partition.
Error Message
successfully causing sup to reset.
Explanation
The supervisor will be reset.
Recommended Action
Error Message
Explanation
be attempted again later.
Recommended Action
want to try again.
OL-15994-03
SYSMGR-2-CONVERT_ZIPPING_FAILED: Failed to zip the converted startup
This message indicates that conversion of the startup configuration failed when system
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-CORE_SAVE_FAILED: [chars]: PID [dec] with message [chars].
The system has detected an error.
No action is required.
SYSMGR-2-CREATE_DONEFILE_FAILED: Creating /var/run/sysmgr.initdone
The initialization of the system could not complete.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-DELETE_BINARY_STARTUP_FAILED: Deletion of binary startup
This message indicates that the deletion of the binary startup configuration failed
If the problem persists, please use the vshboot command 'init system' to
SYSMGR-2-FORMAT_FAILURE_SUP_RESET: Failure to format a partition
The partition used to store non-volatile pss files could not be formatted successfully.
If the problem persists, please contact customer support.
SYSMGR-2-GSYNC_ABORT: Global sync aborted by signal.
The initial synchronization of the services has been aborted. The synchronization will
Use the command 'reload module <mod>' to reset the standby supervisor if you
Cisco NX-OS System Messages Reference
SYSMGR Messages
2-677