Fwm-2 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

FWM Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
interfaces
Error Message
Error Message
Error Message
entries
FWM-3
Error Message
Error Message
Cisco NX-OS System Messages Reference
2-232
FWM-2-STM_LEARNING_RE_ENABLE: Re enabling dynamic learning on all
Explanation Reenabling learning on all interfaces after disable period expired.
No action is required.
Recommended Action
FWM-2-STM_LIMIT_REACHED: [chars]
The system station table reached its capacity - no further MAC addresses could be
Explanation
programmed - administration intervention may be required to avoid this problem in future.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
FWM-2-STM_LOOP_DETECT: [chars]
The system detected loops in the network - administration intervention may be required
Explanation
to avoid this problem in future.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
FWM-2-STM_MCAST_PROG_RE_ENABLE: Re enabling programming multicast
Reenabling programming new multicast entries because number of entries reached
Explanation
below threshold.
No action is required.
Recommended Action
FWM-3-FCFIB_ERR: [chars]
Fcfib has detected an error.
Explanation
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
FWM-3-FCFIB_NO_MEM: Out of memory
Fcfib does not have enough memory to continue proper operation.
Explanation
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03