Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 808

URIB Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
from client \%s\ - unknown to L3VM
Explanation
in the system. The client should be restarted.
Parameters: Table-Id Client name ...
Recommended Action
Error Message
client \%s\ not available - URIB not initialised with L3VM
Explanation
table information. The client should be restarted.
Parameters: Table-Id, Client name ...
Recommended Action
Error Message
memory \%s\: %s
Explanation
shared memory region. The status of the memory is shown in 'show process memory shared'.
Parameters: Name of shared memory region ...
Recommended Action
Error Message
Explanation
for the cause.
Parameters: Failed API, Error Code, Error Description, URIB Function ...
Recommended Action
all VDCs on the system.
Error Message
code %d
Explanation
because of this problem.
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Cisco NX-OS System Messages Reference
2-770
URIB-3-NO_L3VM_INFO_ERROR Format: no L3VM info for table id 0x%08x
A client tried to add some information to URIB and provided a Table-Id that is unknown
Use the 'restart' command to restart the feature and clear this problem.
URIB-3-NOT_INIT_L3VM_ERROR Format: L3VM info for table id 0x%08x from
A client tried to add some information to the URIB, before URIB has registered for the
Use the 'restart' command to restart the feature and clear this problem.
URIB-3-OPEN_CLIENT_SHM_ERROR Format: Failed to open client shared
The calling process failed with the shown error while trying to open the named URIB
Use the 'restart' command to restart the feature and clear this problem.
URIB-3-PSS Format: Error returned from %s, errno: 0x%08x (%s) in %s()
URIB called a PSS API which returned an error. The error reported should be examined
Use 'reload' command to reload the system. Be aware that this problem affects
URIB-3-PTADD_ERROR Format: Could not add %s/%d to the %s pt, error
A severe route table error was encountered. The system may run into more errors
Use the 'system switchover' command to switch over to the standby supervisor.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03