Ethport-3 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

ETHPORT Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
[chars] is not supported
Error Message
([hex] [hex] [hex]) for interface [chars] is not supported
ETHPORT-4
Error Message
Error Message
ETHPORT-5
Error Message
[chars] Kbit
Cisco NX-OS System Messages Reference
2-170
ETHPORT-3-IF_UNSUPPORTED_TRANSCEIVER: Transceiver on interface
Explanation The transceiver for the interface specified in the error message is not a Cisco supported
module.
Replace the module with a compatible transceiver. Contact the Cisco
Recommended Action
Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac.
ETHPORT-3-IF_UNSUPPORTED_TRANSCEIVER_VENDOR: Transceiver vendor
Explanation The transceiver vendor for the interface specified in the error message is not supported.
Replace the module with a compatible transceiver. Contact the Cisco
Recommended Action
Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac.
ETHPORT-4-IF_SFP_ALARM: Interface [chars], [chars]
There was an alarm on the transceiver module.
Explanation
Enter the show interface transceiver details command to obtain more
Recommended Action
information.
ETHPORT-4-IF_SFP_WARNING: Interface [chars], [chars]
There was a warning on the transceiver module.
Explanation
Enter the show interface transceiver details command to obtain more
Recommended Action
information.
ETHPORT-5-IF_BANDWIDTH_CHANGE: Interface [chars],bandwidth changed to
Bandwidth of the interface (port channel) has changed and this change is updated.
Explanation
No action is required.
Recommended Action
Chapter 2 System Messages and Recovery Procedures
OL-15994-03