U6Rib-2 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Nx-os system messages reference
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

U6RIB Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Error Message
U6RIB-3
Error Message
Error Message
Error Message
Error Message
in VRF %s
Cisco NX-OS System Messages Reference
2-750
U6RIB-2-TIMER_LIB Format: %s %s
The timer library returned an error, causing an unrecoverable problem for U6RIB.
Explanation
Use 'reload' command to reload the system. Be aware that this problem affects
Recommended Action
all VDCs on the system.
U6RIB-2-TOO_MANY_CLIENTS Format: %s client \%s\
U6RIB cannot add this client because the U6RIB client limit has already been reached.
Explanation
Parameters: Resource, Client ...
Recommended Action
Restart the component when the system is working.
U6RIB-3-AVLADD_ERROR Format: Could not add %s (0x%08x) to the %s avl
U6RIB was unable to add a piece of data to an AVL data structure.
Explanation
Parameters: Data item, Memory address, Data structure ...
Use 'reload' command to reload the system. Be aware that this problem affects
Recommended Action
all VDCs on the system.
U6RIB-3-AVLINIT_ERROR Format: Could not init %s avl for VRF %s
Explanation
U6RIB was unable to correctly initialize an AVL data structure.
Parameters: AVL name, VRF-name ...
Use 'reload' command to reload the system. Be aware that this problem affects
Recommended Action
all VDCs on the system.
U6RIB-3-ECMP_LDSHR Format: %s
Explanation
Error related to ECMP load-share configuration which will affect load-sharing for
software-switched packets. If parity between hardware and software switching is important, perform
a switchover.
Recommended Action
Requires operator to intervene.
U6RIB-3-GET_INSTANCE_ERROR Format: instance not found for client \%s\
U6RIB could not find its data structures for a client in the shown VRF. The shown VRF
Explanation
should be reconfigured in the client. i.e. in router sub-mode configuration, 'no vrf <vrf-name>'
Parameters: Client, VRF ...
Requires operator to intervene.
Recommended Action
Chapter 2
System Messages and Recovery Procedures
OL-15994-03

Advertisement

Table of Contents
loading

Table of Contents