Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 362

ISIS Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
priority TLVs to make room for type %d TLV
Explanation
router\sLSP,andsolowerpriorityinformation(e.g.,redistRIButedprefixes)hasbeendroppedtomakeroo
m.'
Parameters: Level, LSP Type, TLV Type ...
Recommended Action
LSP, for example by reducing redistRIButed prefixes.
Error Message
limit
Explanation
protocol mandated limitation. Interfaces that are enabled beyond 255 will be igored internally until
the total count drops below 255.
Parameters: Interface Name ...
Recommended Action
router isis, or convert the interface to point-to-point mode. using the command medium p2p
followed by ip router isis.
Error Message
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
over %s
Explanation
ID.
Parameters: The system ID, Interface Name ...
Recommended Action
the command net.
Error Message
Explanation
wait for user to restart it.
Recommended Action
Cisco NX-OS System Messages Reference
2-324
ISIS-4-LSPFULL_FORCED_DROP Format: L%d %s LSP is full, removed lower
There was no storage space left for important routing information in the
Configure IS-IS so that less information will be distRIButed in the router's
ISIS-4-NO_CID Format: Cannot allocate CID for %s\n - Over 255 LANs
IS-IS has been enabled on more than 255 broadcast interfaces and thus exceeded the
Disable IS-IS on one or more broadcast interfaces using the command no ip
ISIS-4-NO_MEM Format: No memory event detected
An attempt to allocate from free memory failed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
ISIS-4-P2P_DUP_SYSID Format: P2P IIH - Duplicate system ID %s detected
IS-IS has detected another system on the indicated P2P that is reusing the local system
Configure either the local or remote router with a different system ID using
ISIS-4-PROC_NO_MEM Format: No memory event, shutting down process
Previously an allocation failed due to no available memory. IS-IS will shut down and
Use the 'restart' command to restart the feature and clear this problem.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03