Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 207

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
ETHPORT-3
Error Message
(Channel error disabled)
Error Message
disabled. Reason:[chars])
Error Message
are removed from suspended state.
Error Message
[chars] are being suspended. (Reason: [chars])
Error Message
Error Message
OL-15994-03
ETHPORT-3-IF_DOWN_CHANNEL_ERR_DISABLED: Interface [chars] is down
This interface belongs to a port channel and the port channel is error disabled.
Explanation
Recommended Action Perform 'shut' and 'no shutdown' on the port channel interface that it belongs
to.
ETHPORT-3-IF_DOWN_ERROR_DISABLED: Interface [chars] is down (Error
The system has detected that the interface has has detected an error during the
Explanation
configuration.
Recommended Action Collect more information about the failed interface using the command 'show
port internal all interface [char]'. In most cases, you can recover using a 'shutdown' followed a 'no
shutdown' on the interface or remove and reinsert the fiber optic cable.
ETHPORT-3-IF_ERROR_VLANS_REMOVED: VLANs [chars] on Interface [chars]
The VLANs on an interface are being removed from the suspended state.
Explanation
No action is required.
Recommended Action
ETHPORT-3-IF_ERROR_VLANS_SUSPENDED: VLANs [chars] on Interface
The VLANs on an interface are being suspended due to some protocol action.
Explanation
No action is required.
Recommended Action
ETHPORT-3-IF_SFP_ALARM: Interface [chars], [chars]
There was an alarm on the transceiver module.
Explanation
Enter the show interface transceiver details command to obtain more
Recommended Action
information.
ETHPORT-3-IF_SFP_ERROR: Interface [chars], [chars]
There was an error on the transceiver module.
Explanation
Recommended Action Enter the show interface transceiver details command to obtain more
information.
Cisco NX-OS System Messages Reference
ETHPORT Messages
2-169