Eth-Port-Sec Messages; Eth-Port-Sec-2 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
EPP-5
Error Message
Error Message
switch

ETH-PORT-SEC Messages

This section contains the ETH-PORT-SEC messages.

ETH-PORT-SEC-2

Error Message
[chars] bound to Port [chars] in Vlan [dec] is trying to access Port [chars] in
Vlan [dec]
Error Message
[chars] moved to [chars] state as host [chars] is trying to access the port in
vlan [dec]
OL-15994-03
EPP-5-EPP_FAILURE: Interface [chars] EPP Failure
Trunk protocol failed.
Explanation
'show epp internal event-history error' will indicate the errors encountered.
Recommended Action
EPP-5-EPP_LOOPBACK: Interface [chars] is looped back to the same
The interface is looped back to another interface on the same switch.
Explanation
Check the connectivity of this interface and ensure that it is connected to
Recommended Action
another switch.
ETH-PORT-SEC-2-ETH_PORT_SEC_SECURITY_VIOLATION_ANOTHER_PORT: Host
Explanation The port is in a violation state because a MAC address that was seen on one port has
been seen on another port too.
No action is required.
Recommended Action
ETH-PORT-SEC-2-ETH_PORT_SEC_SECURITY_VIOLATION_MAX_MAC_VLAN: Port
The port is in a violation state due to an exceeding address count.
Explanation
No action is required.
Recommended Action
ETH-PORT-SEC Messages
Cisco NX-OS System Messages Reference
2-155