Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 546

PORT Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
(dynamic vsan in suspended state)
Explanation
Recommended Action
Error Message
(Isolation due to ELP failure)
Explanation
Recommended Action
Error Message
[chars] is down (Isolation due to ELP failure: class F param error)
Explanation
Recommended Action
Error Message
[chars] is down (Isolation due to ELP failure: class N param error)
Explanation
Recommended Action
Error Message
[chars] is down (Isolation due to ELP failure: invalid payload size)
Explanation
Recommended Action
Error Message
[chars] is down (Isolation due to ELP failure: invalid port name)
Explanation
Recommended Action
Error Message
[chars] is down (Isolation due to ELP failure: invalid switch name)
Explanation
Recommended Action
Cisco NX-OS System Messages Reference
2-508
PORT-5-IF_DOWN_DPVM_VSAN_SUSPENDED: Interface [chars] is down
The specified dynamic VSAN is in suspended state.
Un-suspend the dynamic VSAN.
PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION: Interface [chars] is down
ELP failed on the interface.
Check the output of 'show port internal info' in the 'ELP failure reason' field.
PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION_CLASSF_PARAM_ERR: Interface
ELP failed on the interface due to class F param error.
Configure the attached switchport correctly and try again.
PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION_CLASSN_PARAM_ERR: Interface
ELP failed on the interface due to class N param error.
Configure the attached switchport correctly and try again.
PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION_INVALID_PAYLOAD_SIZE: Interface
ELP failed on the interface due to invalid payload size.
Configure the attached switchport correctly and try again.
PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION_INVALID_PORT_NAME: Interface
ELP failed on the interface due to invalid port name.
Configure the attached switchport correctly and try again.
PORT-5-IF_DOWN_ELP_FAILURE_ISOLATION_INVALID_SWITCH_NAME: Interface
ELP failed on the interface due to invalid switch name.
Configure the attached switchport correctly and try again.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03