Table of Contents
Advertisement
Summary
Configure Switch Device Module
Summary
To save this configuration to the router's running configuration and leave this wizard:
How Do I...
How Do I Configure a Static Route?
Cisco Router and Security Device Manager Version 2.2 User's Guide
2-10
If you are configuring a Gigabit Ethernet interface for routing, you can provide
information about the switch module in this window. It is not required that you
provide this information.
You can provide an IP address and subnet mask for the switch module, and login
credentials required to log on to the the switch module interface.
Check the box at the bottom of the screen if you want to log on to the switch
module after providing the information in this wizard and delivering the
configuration to the router.
This window provides a summary of the configuration changes that you made for
the interface you selected.
Click Finish. SDM saves the configuration changes to the router's running
configuration. Although the changes take effect immediately, they will be lost if
the router is turned off.
If you checked Preview commands before delivering to router in the User
Preferences window, the Deliver window appears. In this window you can view
the CLI commands that you are delivering to the router.
This section contains procedures for tasks that the wizard does not help you
complete.
To configure a
static
route:
Chapter 2
LAN Wizard
OL-4015-08
Advertisement
Table of Contents
Troubleshooting
