Port-4 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Nx-os system messages reference
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

Chapter 2
System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
PORT-5
Error Message
has been disabled as Enterprise Package license could not be checked out
Error Message
allowed to come up even with SFP checksum error
Error Message
is not allowed to come up (received as all zeros wwn from peer
Error Message
is not allowed to be operational due to port config failure for reason: [chars]
([hex])
Error Message
(Administratively down)
Error Message
(Error disabled - bit error rate too high)
OL-15994-03
PORT-5-EC_DISABLED_AS_LICENSE_NOT_PRESENT: Extended credit feature
The Enterprise Package license is not available, so the extended credit feature has been
Explanation
disabled even though it was present in startup config.
Install the Enterprise Package license and re-enable the extended credit
Recommended Action
feature.
PORT-5-IF_BRINGUP_ALLOWED_FCOT_CHECKSUM_ERR: Interface [chars] is
SFP checksum on this interface failed.
Explanation
Recommended Action
Try to replace the SFP on this interface.
PORT-5-IF_BRINGUP_FAILED_ALL_ZERO_PEER_WWN_RCVD: Interface [chars],
Check peer interface configuration.
Explanation
No action is required.
Recommended Action
PORT-5-IF_BRINGUP_NOT_ALLOWED_PORT_CONFIG_FAILURE: Interface [chars]
Check interface configuration.
Explanation
Try to change the configuration on the interface with the current available
Recommended Action
hardware capability.
PORT-5-IF_DOWN_ADMIN_DOWN: Interface [chars] is down
The system has detected that the interface has been configured to be administratively
Explanation
down.
Perform the following commands to bring up the interface: 'config terminal',
Recommended Action
'interface [char]', 'no shutdown'.
PORT-5-IF_DOWN_BIT_ERR_RT_THRES_EXCEEDED: Interface [chars] is down
The port has detected too high bit error rate in frames received from attached device.
Explanation
Check the attached device; replace it if needed.
Recommended Action
Cisco NX-OS System Messages Reference
PORT Messages
2-505

Advertisement

Table of Contents
loading

Table of Contents