Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 55

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
interface : [chars]
Explanation
Recommended Action
Error Message
TCAM failed(ASIC: [dec], [chars] TCAM, Address: [dec], Num Entries: [dec], Error:
[chars]).
Explanation
Num Entries: [dec] Error: [chars]).
Recommended Action
Error Message
[dec]) TCAM entry read from hardware TCAM (FWD-Engine: [dec], [chars] TCAM,
Address: [dec]), Ignoring this entry.
Explanation
[chars] TCAM, Address: [dec]) Ignoring this entry.
Recommended Action
Error Message
TCAM failed(ASIC: [dec], [chars] TCAM, Address: [dec], Num Entries: [dec], Error:
[chars]).
Explanation
Num Entries: [dec] Error: [chars]).
Recommended Action
Error Message
reason: [hex].
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
OL-15994-03
ACLTCAM-2-ACL_TCAM_NO_TCAM_LEFT: ACLTCAM resource exhausted for
ACLTCAM hardware resource is completely used.
No action is required.
ACLTCAM-2-ACL_TCAM_PHY_TCAM_READ_FAILED: [chars] read from hardware
[chars] read from hardware TCAM failed(ASIC: [dec], [chars] TCAM, Address: [dec],
No action is required.
ACLTCAM-2-ACL_TCAM_PHY_TCAM_READ_INVALID: Invalid([chars], value:
Invalid([chars], value: [dec]) TCAM entry from hardware TCAM(FWD-Engine: [dec],
No action is required.
ACLTCAM-2-ACL_TCAM_PHY_TCAM_WRITE_FAILED: [chars] write to hardware
[chars] write to hardware TCAM failed(ASIC: [dec], [chars] TCAM, Address: [dec],
No action is required.
ACLTCAM-2-ACL_TCAM_PSS_FAILURE: Failed to do PSS operation: [chars],
The system has failed to do a PSS operation [chars]. [hex] is the reason.
No action is required.
ACLTCAM-2-PSS_OPEN_FAILED: PSS open failed - [hex].
Persistent database handle could not be obtained for ACLTCAM. [hex] is the error.
No action is required.
Cisco NX-OS System Messages Reference
ACLTCAM Messages
2-17