Ivr-2 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
rewrite entries for pWWN [chars] on incoming VSAN [dec]. Device may not be able
to communicate with its peer devices, failure reason code: [hex]
Explanation
rewrite entries. This can happen if there are too many devices in Inter-VSAN zone or too many local
VSANs in VSAN topology.
Recommended Action
Also, reduce the number of redundant transit VSANs, if any.
Error Message
port WWN [chars] could not be restored because it was incompatible with the current
NAT mode([dec]). This probably happened because NAT mode was modified without
completely deactivating the active IVR zoneset
Explanation
deactivating the active IVR zone set.
Recommended Action
Error Message
rewrite entries for pWWN [chars] on incoming VSAN [dec]. Device may not be able
to communicate with its peer devices
Explanation
VSAN rewrite entries. This can happen if there are too many devices in Inter-VSAN zone or too
many local VSANs in VSAN topology.
Recommended Action
active IVR zone set to fewer switches. Also, reduce the number of redundant transit VSANs, if any.
Error Message
Domain [chars]
Explanation
unused virtual domain [dec] from the fcdomain list in that VSAN. The virtual domain still remains
in the fcdomain list and therefore it would not be available in that VSAN for assignment.
Recommended Action
remove the unused virtual domain(s) from the fcdomain list.
OL-15994-03
IVR-2-DEVICE_FCID_REWRITE_FAILURE: Failure while programming FCID
Failed to program FCID rewrite entries probably because the hardware ran out of FCID
Reduce the number of devices involved in IVR in the active IVR zone set.
IVR-2-DEVICE_STATE_INCOMPATIBLE_WITH_NAT_MODE: State for device with
This probably happened because NAT mode was modified without completely
The switch needs to be rebooted.
IVR-2-DEVICE_VSAN_REWRITE_FAILURE: Failure while programming VSAN
Failed to program VSAN rewrite entries probably because the hardware ran out of
Reduce the number of domains involved in IVR by moving the members of
IVR-2-INTEROP_MODE_2_OR_3_BF_FAILED: [chars] VSAN [dec] Virtual
Build Fabric (BF) failed in VSAN [dec]. The BF was initiated in order to remove an
Perform a manual build fabric using fcdomain's interface if you would like to
Cisco NX-OS System Messages Reference
IVR Messages
2-329