Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 803

Nx-os system messages reference
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

Chapter 2
System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
known epid (%u)
Explanation
client. The client probably restarted ungracefully and URIB has the old id.
Parameters: Client, Expected epid, Received epid ...
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Parameters: Thread name, Thread operation ...
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
OL-15994-03
URIB-3-DEL_ERROR Format: Could not delete %s/%d from %s
A error was encountered. The system may run into more errors because of this problem.
Use the 'system switchover' command to switch over to the standby supervisor.
URIB-3-EPID_MIS_MATCH_ERROR Format: \%s\ epid (%u) does not match
The id a client provided does not match the id that URIB currently has stored for the
Use the 'restart' command to restart the feature and clear this problem.
URIB-3-FILE_OPEN_ERROR Format: File open error: %s
This message is for internal debugging only.
No action is required.
URIB-3-FILE_WRITE_ERROR Format: File write error: %s
This message is for internal debugging only.
No action is required.
URIB-3-GENERAL_CRIB_ERROR Format: %s
CRIB not in use.
No action is required.
URIB-3-GENERAL_PTHREAD_ERROR Format: Thread %d: %s
The POSIX pthread library returned an error to URIB.
Use the 'system switchover' command to switch over to the standby supervisor.
Cisco NX-OS System Messages Reference
URIB Messages
2-765

Advertisement

Table of Contents
loading

Table of Contents