Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 674

SVC Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
) Timeout due to excessive processing time [chars]
Explanation
disk timeout conditions have been detected. The problem is probably caused by a failure of some
other component on the SAN.
Recommended Action
this cluster. 2. If problems are found, mark this error as fixed. 3. If no switch or disk controller
failures can be found, take an error log dump and call your hardware support center.
Error Message
SS_EID_VL_ER_LOCAL_PORT_EXCLUDED ) Local FC port excluded [chars]
Explanation
Recommended Action
controller. 3. If all disk controllers show good status, mark the error you have just repaired as fixed.
4. If the error persists and no other cause can be determined, replace the Caching Services Module.
Error Message
Login excluded [chars]
Explanation
Recommended Action
cable, switch to remote port. 2. Start a cluster discovery operation to recover the login. 3. Check the
status of the disk controller. If all disk controllers show a good status, mark the error you have just
repaired as fixed. 4. If the error persists and no other cause can be determined, replace the Caching
Services Module.
Error Message
SS_EID_VL_ER_LUN_RESOURCE_RAN_OUT ) Too many LUNs were presented to a node [chars]
Explanation
node.
Recommended Action
cluster discovery operation to find devices. 3. List all connected managed disks. Check that the
configuration is as expected. Mark the error you have just repaired as fixed.
Cisco NX-OS System Messages Reference
2-636
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_IO_TIMEOUT_OVERALL
A managed disk has timed out. This error has been reported because a large number of
1. Repair problems on all disk controllers and switches on the same SAN as
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
A local fibre-channel port has been excluded.
1. Repair the fibre-channel network fabric. 2. Check the status of the disk
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_LOGIN_EXCLUDED )
Login has been excluded.
1. In the sequence shown, exchange the FRUs for new FRUs: Fibre Channel
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
The configuration is not valid. Too many devices have been presented to the cluster or
1. Remove unwanted devices from the fibre-channel network fabric. 2. Start a
Chapter 2 System Messages and Recovery Procedures
OL-15994-03