U6Rib-4 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
0x%08x
U6RIB-5
Error Message
Error Message
%d != %d
Error Message
Error Message
same pid
Error Message
OL-15994-03
U6RIB-4-UFDM_ACKNOT_FOUND Format: Could not find UFDM buffer with ptr
Explanation Ack received for a UFDM buffer that U6RIB does not know about.
Parameters: Memory address of UFDM buffer ...
No action is required.
Recommended Action
U6RIB-5-API_INIT_SEM_CLEAR Format: Cleared the API semaphore from %d
The API semaphore was in an unexpected state, and was restored to a correct value.
Explanation
Parameters: Value of semaphore ...
No action is required.
Recommended Action
U6RIB-5-CLT_EVENT_STATE Format: Client \%s\ unexpected %s event state
An unexpected but recoverable event has occurred.
Explanation
Recommended Action No action is required.
U6RIB-5-CLT_NO_BUF Format: Client \%s\ %s event has no buffer
An unexpected but recoverable event has occurred.
Explanation
No action is required.
Recommended Action
U6RIB-5-DUP_REGISTER Format: Client \%s\ register more than once with
A client tried to register more than once with U6RIB. The re-registration was igored.
Explanation
No action is required.
Recommended Action
U6RIB-5-GENERAL_FAILURE Format: Failed to %s
The logged action failed.
Explanation
Use the 'system switchover' command to switch over to the standby supervisor.
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Cisco NX-OS System Messages Reference
U6RIB Messages
2-757