Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 369

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
virtual fcid and dynamic pfcid entries
Error Message
configured persistent virtual domain/fcid could not be assigned
Error Message
from native VSAN [dec] conflicts with native VSAN [dec] for the same virtual domain
Error Message
generated FCID conflicts with fcid assigned to WWN [chars]. Please configure fcid
for WWN [chars] too
IVR-3
Error Message
the fabric NAT mode inconsistency
OL-15994-03
IVR-2-PERSISTENT_VIRTUAL_FCID_CONFLICT_WITH_AUTOLEARN: Persistent
Explanation This can happen if conflict happens during persistent virtual domain, or virtual fcid
entry configuration.
Please assign a non-conflict persistent virtual domain or fcid entry with
Recommended Action
current dynamic entries.
IVR-2-PERSISTENT_VIRTUAL_FCID_UNAVAILABLE: to vsan [dec] because the
Explanation This can happen if the virtual domain/fcid configured by the user is - a) Already in use
(either by IVR or a real switch) b) Not allowed due to interop mode or allowed domain list.
Recommended Action Please make sure that the configured virtual domain/fcid is allowed and
available for use.
IVR-2-VIRTUAL_DOMAIN_CONFLICT: In VSAN [dec] virtual domain [dec]
Currently advertised virtual domain [dec] in VSAN [dec] is native to VSAN [dec]. This
Explanation
switch has learned of a device that is member of active IVR zone and has the same domain ID, but
belongs to a different native VSAN. This device would not be advertised in that VSAN until the
domain conflict is resolved.
No action is required.
Recommended Action
IVR-2-VIRTUAL_FCID_UNAVAILABLE: to vsan [dec] because the internally
This can happen if the virtual domain/fcid internally configured is already in use by
Explanation
another active device.
Recommended Action Please assign a different persistent virtual fcid by command.
IVR-3-AAM_MODE_CANNOT_CHANGE: AAM mode cannot be changed. Might cause
The IVR NAT is not enabled.
Explanation
Recommended Action No action is required.
Cisco NX-OS System Messages Reference
IVR Messages
2-331