FCDOMAIN Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
FCDOMAIN-2
Error Message
WWN [chars]
Error Message
[chars])
Error Message
failed
Error Message
failed
Error Message
Cisco NX-OS System Messages Reference
2-192
FCDOMAIN-2-DOMS_CONFLICT: Conflict detected: ([dec]) domain ID [dec]
Conflict detected ([dec]) domain ID [dec] with WWN [chars].
Explanation
Recommended Action
Check which switches have the same WWN and change either one; then
change either one's domain ID.
FCDOMAIN-2-EPORT_ISOLATED: Isolation of interface [chars] (reason:
Fcdomain has isolated interface [chars] (reason: [chars].) Perform a show interface.
Explanation
Based on the reason specified, you might have to ensure domains are adequate and unique in the
VSAN and perform a disruptive restart [fcdomain restart disruptive VSAN <VSAN-id>] or to
reinitialize the port.
No action is required.
Recommended Action
FCDOMAIN-2-FC2_INITIALIZATION_FAILED: FC initialization sequence
The fcdomain has not been able to complete the initialization sequence with the Fibre
Explanation
Channel subsystem. fcdomain depends on resources not available at the moment: the switch might
be short in memory or some other component might be unable to provide the necessary information
to fcdomain.
No action is required.
Recommended Action
FCDOMAIN-2-FC2_SET_SOCKOPT_DM_SOCK_FAILED: set sockopt to FC2 Service
Fcdomain has not been able to setsockopt to the FC2 module.
Explanation
No action is required.
Recommended Action
FCDOMAIN-2-FC2BIND_FAILED: Bind to FC2 Service failed
Fcdomain has not been able to contact the FC2 module.
Explanation
No action is required.
Recommended Action
Chapter 2
System Messages and Recovery Procedures
OL-15994-03