Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 811

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
unexpected error %d
Error Message
Error Message
URIB-4
Error Message
Error Message
%s (%d) resolve buffer
Error Message
\%s\sdeleterequest'
OL-15994-03
URIB-3-UFDM_MTSSEND_FAILURE Format: MTS send; to UFDM failed with
Explanation URIB was unable to send a route update to UFDM. This means there will be a route
missing from the FIB.
Use the 'system switchover' command to switch over to the standby supervisor.
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
URIB-3-XCHECK_ERROR Format: ksink_event_wait 0x%08x returned error %s
This messages are for internal debugging only.
Explanation
Parameters: Memory address, Error ...
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
URIB-3-XRI_TYPE_ERROR Format: Unknown XRI type %u
URIB detected unknown eXtended route information while displaying a next-hop
Explanation
address.
No action is required.
Recommended Action
URIB-4-INVALID_PIB Format: %s %s
Explanation A bad protocol information block was encountered in the given situation.
Parameters: Situation, Message ...
No action is required.
Recommended Action
URIB-4-NH_RESOLV_LUKUP Format: Could not find %s/%d while processing
Explanation Unresolved nexthop not cleaned up properly.
No action is required.
Recommended Action
URIB-4-RTDEL_ERROR Format: Could not find prefix %s/%d, client
Route delete request was received for a non-existing route.
Explanation
Parameters: Prefix, Prefix Length, Client ...
No action is required.
Recommended Action
Cisco NX-OS System Messages Reference
URIB Messages
2-773