Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 94

BGP Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
route-map %s
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
policy %s, error: %s
Explanation
Recommended Action
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message
policy %s, error: %s
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
policy %s, error: %s
Explanation
Recommended Action
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message
Explanation
out of memory.
Parameters: VRF name, Address-family, Table name, Operation ...
Recommended Action
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message
initialize
Explanation
Recommended Action
Cisco NX-OS System Messages Reference
2-56
BGP-3-PLCYOUT Format: Cannot add reference to policy out info for
Use the 'restart' command to restart the feature and clear this problem.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-PLCYRNHATTACH Format: Couldn't attach to policy RNH info for
An internal error occurred in using a policy. BGP_EXPL_NO_MEM_MAYBE.
If BGP ran out of memory, add memory to the router or change the network
BGP-3-PLCYRNHDETACH Format: Couldn't detach from policy RNH info for
An internal software error occurred.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-PLCYRNHSETUP Format: Couldn't setup rnh notifications for
An internal error occurred in using a policy. BGP_EXPL_NO_MEM_MAYBE.
If BGP ran out of memory, add memory to the router or change the network
BGP-3-RDINFO Format: VRF %s, %s, table %s: rdinfo %s failed
BGP was unable to initialize an internal datastructure. The BGP process may have run
If BGP ran out of memory, add memory to the router or change the network
BGP-3-RESTARTINIT Format: Unable to determine restart status and
An unrecoverable error has occurred during BGP initialization.
Use the 'restart' command to restart the feature and clear this problem.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03