Urib-3 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

URIB Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
Parameters: Filename, Line number, Expression ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Parameters: Data item, Memory address, Data structure ...
Recommended Action
all VDCs on the system.
Error Message
Explanation
Parameters: AVL name, VRF-name ...
Recommended Action
all VDCs on the system.
Error Message
Explanation
Parameters: Client name, Error ...
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' CLI command.
Error Message
failure from %s order to %s order
Explanation
Parameters: order, order ...
Recommended Action
Error Message
Explanation
errors because of this problem.
Recommended Action
Cisco NX-OS System Messages Reference
2-764
URIB-3-ASSERT_ERROR Format: %s:%d: Assertion \%s\ failed.
An internal software error has occurred. An assertion held to be true failed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
URIB-3-AVLADD_ERROR Format: Could not add %s (0x%08x) to the %s avl
URIB was unable to add a piece of data to an AVL data structure.
Use 'reload' command to reload the system. Be aware that this problem affects
URIB-3-AVLINIT_ERROR Format: Could not init %s avl for VRF %s
URIB was unable to correctly initialize an AVL data structure.
Use 'reload' command to reload the system. Be aware that this problem affects
URIB-3-CMI_MTSSEND_FAILURE Format: mts_send failure for client %s: %s
URIB was unable to send an MTS message to a particular client
Use the 'system switchover' command to switch over to the standby supervisor.
URIB-3-CMI_PAYLOAD_CONV_ERR Format: CMI payload conversion error
The cmi payload conversion did not occur successfully.
No action is required.
URIB-3-COPY_ERROR Format: Could not copy %s for %s/%d
A error was encountered during route optimization. The system may run into more
No action is required.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03