Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 661

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
status = [hex] [[chars]] vdc [dec], tree id [dec], num ports [dec], ports [chars]
state [chars], opcode [chars], msg id ([dec]), rr_token [hex]
Explanation
Recommended Action
Error Message
after [dec] sec. vdc [dec], tree id [dec], num ports [dec], ports [chars] state
[chars], opcode [chars], msg id ([dec]), rr_token [hex]
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
during ISSU caused by a topology change in the network. Peer on [chars] [chars]
could not be Disputed
Explanation
undergoing ISSU. Since STP cannot change the port state to blocking on the Linecard undergoing
ISSU, it will first try to prevent the Loop by causing a Dispute on the peer ports forcing them into
blocking state. But if the peer does not support Dispute mechanism, and STP detects a potential
Loop, it will reset the Linecard to prevent the Loop.
Recommended Action
Error Message
consistency restored.
Explanation
tree will now unblock the listed interface of the listed spanning tree instance as appropriate.
Recommended Action
Error Message
detected].
Explanation
normal spanning tree state.
Recommended Action
OL-15994-03
STP-2-SET_PORT_STATE_FAIL: Port state change req to PIXM failed,
The port set port state hasfailed. Checkthe port.
No user action is required.
STP-2-SET_PORT_STATE_TIMEOUT: Port state change req to PIXM timedout
The port set port state has timed outCheck the port.
No user action is required.
STP-2-STP_INIT: STP initialization of [chars] [chars]
STP initialization has failed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
STP-2-STP_ISSU_LC_RESET: STP resetting LC[dec] to prevent Loops
This can happen as a result of a topology change in the network while the Linecard was
No user action is required.
STP-2-UNBLOCK_CONSIST_PORT: Unblocking port [chars] on [chars]. Port
The Port VLAN ID and/or Port Type inconsistencies have been resolved and spanning
No user action is required.
STP-2-UNBLOCK_DETECTED_PVST_PEER: Unblocking port [chars] [PVST peer
The listed interface has stopped receiving SSTP BPDUs and so will be restored to
No user action is required.
Cisco NX-OS System Messages Reference
STP Messages
2-623