Span-6; Spi-Slot# Messages; Spi-Slot#-2; Stp Messages - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

SPI-SLOT# Messages

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
switchover.
SPI-SLOT# Messages
This section contains the SPI-SLOT# messages.

SPI-SLOT#-2

Error Message

STP Messages

This section contains the STP messages.
STP-2
Error Message
enabled. Disabling port.
Cisco NX-OS System Messages Reference
2-618
SPAN-6-STATELESS_SWITCHOVER: Span is starting stateless after
Explanation Active sessions are not preserved across switchover. Span is starting stateless and the
configuration will be reapplied to get back the active configuration.
No action is required.
Recommended Action
SPI-SLOT#-2-SPI_INFO: [chars]
SPI Informational message.
Explanation
No action is required.
Recommended Action
STP-2-BLOCK_BPDUGUARD: Received BPDU on port [chars] with BPDU Guard
A BPDU was received in the interface specified in the error message that has the
Explanation
spanning tree BPDU Guard feature enabled. As a result, the interface was administratively shut
down.
Either remove the device sending BPDUs or disable the BPDU Guard feature.
Recommended Action
The BPDU Guard feature can be locally configured on the interface or globally configured on all
ports that have portfast enabled. After the conflict has been resolved, re-enable the interface by
entering the <CmdBold>no shutdown<NoCmdBold> command in interface configuration mode.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03