Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 791

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
(%d)
Explanation
Parameters: Requestor, Error String, Error ...
Recommended Action
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
Explanation
Parameters: Queue name, Error ...
Recommended Action
Error Message
Explanation
error.
Recommended Action
Error Message
from client \%s\ - unknown to L3VM
Explanation
unknown in the system. The client should be restarted.
Parameters: Table-Id Client name ...
Recommended Action
Error Message
client \%s\ not available - U6RIB not initialised with L3VM
Explanation
table information. The client should be restarted.
Parameters: Table-Id, Client name ...
Recommended Action
Error Message
memory \%s\: %s
Explanation
shared memory region. The status of the memory is shown in 'show process memory shared'.
Parameters: Name of shared memory region ...
Recommended Action
OL-15994-03
U6RIB-3-MTS_OPTIONS Format: MTS option set failed for opcode %s: %s
U6RIB was unable to set options for an MTS opcode
Use the 'system switchover' command to switch over to the standby supervisor.
U6RIB-3-MTS_RECV Format: Error returned from mts_recv(%s), errno: %s
An MTS API returned an error while U6RIB was receiving on an MTS queue.
No action is required.
U6RIB-3-MTS_REGISTER Format: mts_register failed for u6rib: %s
U6RIB was unable to register client for U6RIB notifications, causing an unrecoverable
Use the 'restart' command to restart the feature and clear this problem.
U6RIB-3-NO_L3VM_INFO_ERROR Format: no L3VM info for table id 0x%08x
A client tried to add some information to U6RIB, and provided a Table-Id that is
Use the 'restart' command to restart the feature and clear this problem.
U6RIB-3-NOT_INIT_L3VM_ERROR Format: L3VM info for table id 0x%08x from
A client tried to add some information to the U6RIB, before U6RIB has registered for
Use the 'restart' command to restart the feature and clear this problem.
U6RIB-3-OPEN_CLIENT_SHM_ERROR Format: Failed to open client shared
The calling process failed with the shown error while trying to open the named U6RIB
Use the 'restart' command to restart the feature and clear this problem.
Cisco NX-OS System Messages Reference
U6RIB Messages
2-753