Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 520

PLATFORM Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
connection fault detected but failed to perform bus switchover(BUS_A to BUS_B)
Explanation
Recommended Action
Error Message
chassis.
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
[dec]
Explanation
Recommended Action
Error Message
is not supported in this chassis. (Chassis Incompatible card)
Explanation
Incompatible card).
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
[dec]
Explanation
Recommended Action
Cisco NX-OS System Messages Reference
2-482
PLATFORM-2-PFM_FATW_BUS_SWITCH_FAIL: Backplane two wire [chars] bus
Could not access some modules using BUS_A, but can access using BUS_B.
Enter a 'show platform internal error'.
PLATFORM-2-PFM_IMG_CMPT_FAIL: Image version is not supported in this
This image version is not supported in this chassis.
Sup-platform.
PLATFORM-2-PFM_LC_BOOT_DEV_ABSENT: No bootflash found in Module [dec]
No bootflash found.
Try to put in a bootflash in the module and try again.
PLATFORM-2-PFM_LC_BOOT_DEV_FAIL: Bootflash access error in Module
Bad bootflash/corrupted file system.
Try to put in a known good bootflash in the module and try again.
PLATFORM-2-PFM_LC_MOD_POWERED_DOWN: Module [dec] Powered Down. Module
Module Powered Down, because Module is not supported in this chassis. (Chassis
Enter a 'show module' to see the Power Down reason.
PLATFORM-2-PFM_LC_NETBOOT_FAIL: Netboot for Module [dec] failed
Netboot failed.
Try to replace the BIOS in the module.
PLATFORM-2-PFM_LC_REGISTRATION_FAIL: Could not register with Module
Module registration failed.
Try to replace the module.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03