Ospf Messages; Ospf-1 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
Parameters: Message, Destination ...
Recommended Action
Error Message
Explanation
Parameters: Size, Error ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
data structures.
Parameters: Slab Type ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Parameters: Thread name, Thread Id, Error ...
Recommended Action
Error Message
Explanation
Parameters: Active or Standby Supervisor ...
Recommended Action
Error Message
Explanation
Parameters: Timer, Interface Id ...
Recommended Action
OL-15994-03
OSPF-1-MQSEND Format: Unable to send message %s to %s
An internal software error occurred.
Use the 'restart' command to restart the feature and clear this problem.
OSPF-1-NOMEM Format: Malloc (%ld bytes) failed for: %s
The router did not have enough memory to store mentioned data structures.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
OSPF-1-SLABS Format: Could not create %s slabs
The router did not have enough memory to reserve space in advance for certain slab
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
OSPF-1-STARTTHREAD Format: Unable to start thread %s (%d), error %s
An internal software error occurred.
Use the 'restart' command to restart the feature and clear this problem.
OSPF-1-TAG Format: Unable to retrieve service tag on %s supervisor
An internal software error occurred.
Use the 'restart' command to restart the feature and clear this problem.
OSPF-1-TIMER Format: Unable to create %s timer on interface %s
An internal software error occurred.
Use the 'restart' command to restart the feature and clear this problem.
Cisco NX-OS System Messages Reference

OSPF Messages

2-429