Vrrp-Cfg-3; Vrrp-Cfg-5 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

VRRP-ENG Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
[chars]
VRRP-ENG Messages
This section contains the VRRP-ENG messages.
VRRP-ENG-2
Error Message
Error Message
interface [chars]. Invalid IP configuration. Reason: [chars]
Error Message
Going to init state
VRRP-ENG-3
Error Message
Cisco NX-OS System Messages Reference
2-806
VRRP-CFG-5-VR_DELETED: VR [chars]group [dec] removed from interface
Explanation The specified VRRP group has been successfully deleted on interface [chars].
No action is required.
Recommended Action
VRRP-ENG-2-ALLOC_MEMORY: Memory allocation failed
Explanation The service failed to allocate a block of dynamic memory.
No action is required.
Recommended Action
VRRP-ENG-2-INVALID_CONFIG: Cannot start the VR[chars] [dec] on the
The specified VR on interface [chars] is enabled but the IP configuration is not valid
Explanation
because of [chars].
Show interface to check that the IP address of the interface is configured and
Recommended Action
it is in the same subnet of the virtual router address.
VRRP-ENG-2-VR_FAILURE: Error in VR[chars] [dec] interface [chars].
The VR [dec] on the interface [chars] is in init state for an internal error.
Explanation
Show interface to check the status of the interface, show configuration, status
Recommended Action
and statistics of the specified virtual router, enable the VRRP debug and shut/ no shut the specified
virtual router.
VRRP-ENG-3-INIT_FAILED: Initialization failed. Component [chars]
The system has detected that the service has failed to start. The failure occurred while
Explanation
initializing the component [chars].
Enter the show processes command to check the status of the other processes,
Recommended Action
debug the specified component.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03