Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 679

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
is unable to see the FC fabric [chars]
Explanation
Recommended Action
Error Message
domain error [chars]
Explanation
Recommended Action
same IO group. If so, determine what the configuration should be. Remove one of the nodes and add
a node to the IO group which is not on the same Caching Services Module. If not, ask IBM Product
Support for assistance.
Error Message
Node repeatedly crashing due to a software fault [chars]
Explanation
Recommended Action
3. Ensure that the software is at the latest level on the cluster. If not, upgrade the cluster with the
latest level of code. 4. If the error continues, ask IBM Product Support for assistance.
Error Message
Node data not found - node rejected from cluster [chars]
Explanation
Recommended Action
the node data and, if so, follow the actions for that error. If no other error was recorded, the node
may have lost power without saving data or been reset. Attempt to determine the cause of the power
loss or reset. If no cause can be determined, then: 1. Re-install the code on the node. The node will
have to be removed and re-added back to the cluster. 2. Ensure that the software is at the latest level
on the cluster. If not, upgrade the cluster and if necessary repeat step 1 with the latest level of code.
3. If the error continues, ask IBM Product Support for assistance. It may be necessary to replace the
Caching Services Module.
Error Message
Explanation
Recommended Action
OL-15994-03
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_NO_FABRIC ) The node
No active/functioning logical FC port was detected by the software.
Reload the node. If the problem persists, replace the Caching Services Module.
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_PWR_DMN_ERR ) Power
The two nodes in an IO group are on the same Caching Services Module.
Determine if both nodes on the Caching Services Module are in fact in the
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_REPEATED_ASSERTS )
The number of software faults has exceeded the maximum allowed for the time period.
1. Delete the node from the cluster. 2. Try to add the node back into the cluster.
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_RESET_AND_REJECT )
Node data was not found. The node has been rejected from the from cluster.
Examine error logs to determine if another recorded error caused the loss of
SVC-3-NODE_ERR_MSG: [chars]
Syslog message from a SVC interface node.
No action is required.
Cisco NX-OS System Messages Reference
SVC Messages
2-641