Ipv6 Rip Interface Recv-Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IPv6 Commands

ipv6 rip interface recv-status

Configures IPv6 RIPng interface "Receive" status. When this status is set to "enable", packets can be
received on this interface. When it is set to "disable", packets will not be received on this interface.
ipv6 rip interface if_name recv-status {enable | disable}
Syntax Definitions
if_name
enable | disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
RIPng must be loaded
ets on the interface.
Examples
-> ipv6 rip interface Test_Lab recv-status disable
Release History
Release 6.1; command was introduced.
Related Commands
ipv6 redist
ipv6 rip status
ipv6 rip interface send-status
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceRecvStatus
OmniSwitch CLI Reference Guide
IPv6 interface name.
Interface "Receive" status.
default
enable
(ipv6 load rip) and enabled
Loads RIPng into memory.
Enables/disables RIPng on the switch.
Configures IPv6 RIPng interface "Send" status.
June 2012
(ipv6 rip status)on the switch to send or receive pack-
page 15-85