Ipv6 Rip Interface Send-Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ipv6 rip interface send-status

Configures IPv6 RIPng interface "Send" status. When this status is set to "enable", packets can be sent
from this interface. When it is set to "disable", packets will not be sent from this interface.
ipv6 rip interface if_name send-status {enable | disable}
Syntax Definitions
if name
enable | disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
RIPng must be loaded
ets on the interface.
Examples
-> ipv6 rip interface Test_Lab send-status enable
Release History
Release 6.1; command was introduced.
Related Commands
ipv6 redist
ipv6 rip status
ipv6 rip interface recv-status
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceSendStatus
page 15-86
IPv6 interface name.
Interface "Send" status.
default
enable
(ipv6 load rip) and enabled
Loads RIPng into memory.
Enables/disables RIPng on the switch.
Configures IPv6 RIPng interface "Receive" status.
(ipv6 rip status)on the switch to send or receive pack-
OmniSwitch CLI Reference Guide
IPv6 Commands
June 2012