Sbus<N>:Flexray:trigger:frame:ccbase - Agilent Technologies InfiniiVision 3000 Programmer's Manual

26
:SBUS<n> Commands
:SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase
Command Syntax
:SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase <cycle_count_base>
<cycle_count_base> ::= integer from 0-63
The :SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase command sets the base of
the FlexRay cycle count (in the frame header) to trigger on. The cycle
count base setting is only valid when the FlexRay trigger mode is set to
FRAME.
Query Syntax
:SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase?
The :SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase? query returns the current
cycle count base setting for the FlexRay frame trigger setup.
Return Format
<cycle_count_base><NL>
<cycle_count_base> ::= integer from 0-63
See Also •
•
650
(see page 1088)
"Introduction to :TRIGger Commands"
":SBUS<n>:FLEXray:TRIGger"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 843
on page 645