Save:waveform[:Start] - Agilent Technologies InfiniiVision 3000 Programmer's Manual

25
:SAVE Commands

:SAVE:WAVeform[:STARt]

Command Syntax
:SAVE:WAVeform[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:WAVeform[:STARt] command saves oscilloscope waveform data
to a file.
Be sure to set the :SAVE:WAVeform:FORMat before saving waveform data. If the format is
N O T E
NONE, the save waveform command will not succeed.
If a file extension is provided as part of a specified <file_name>, and it does not match the
N O T E
extension expected by the format specified in :SAVE:WAVeform:FORMat, the format will be
changed if the extension is a valid waveform file extension.
See Also
•
•
•
•
•
588
(see page 1088)
"Introduction to :SAVE Commands"
":SAVE:WAVeform:FORMat"
":SAVE:WAVeform:LENGth"
":SAVE:FILename" on page 577
":RECall:SETup[:STARt]"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 575
on page 589
on page 590
on page 571