Channel<N>:Scale - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

10
:CHANnel<n> Commands
:CHANnel<n>:SCALe
Command Syntax
:CHANnel<n>:SCALe <scale>[<suffix>]
<scale> ::= vertical units per division in NR3 format
<suffix> ::= {V | mV}
<n> ::= 1 to (# analog channels) in NR1 format
The :CHANnel<n>:SCALe command sets the vertical scale, or units per
division, of the selected channel.
If the probe attenuation is changed, the scale value is multiplied by the
probe's attenuation factor.
Query Syntax
:CHANnel<n>:SCALe?
The :CHANnel<n>:SCALe? query returns the current scale setting for the
specified channel.
Return Format
<scale value><NL>
<scale value> ::= vertical units per division in NR3 format
See Also
•
•
•
280
(see page 1208)
"Introduction to :CHANnel<n> Commands"
":CHANnel<n>:RANGe"
":CHANnel<n>:PROBe"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 279
on page 273
on page 264