Table of Contents
Advertisement
11) Install the hypoid driven gear on differential
case.
NOTE:
• Before installing bolts, apply Lock Tite to bolt
threads.
Lock Tite:
THREE BOND 1324 (Part No. 004403042)
• Tighten diagonally while tapping the bolt heads.
Tightening torque:
⋅
62 N
m (6.3 kgf-m, 45.6 ft-lb)
12) Press the side bearing into differential case us-
ing ST.
ST 498485400
DRIFT
ST
13) Assemble holders.
(1) Install the oil seal into holder RH and LH.
ST 498447100
INSTALLER
ST
Rear Differential (VA-type)
ST 398477702
CAUTION:
Make sure that the oil seal, bearing outer race
and cone are properly assembled.
NOTE:
Be careful not to hit the teeth against the case.
DI-00068
14) Perform the backlash adjustment between the
DI-00095
hypoid driven gear and drive pinion, and preload
adjustment of differential side bearing.
ST 498427200
DI-00166
DI-59
(2) Install the bearing race into holder RH and
LH.
DRIFT
ST
(3) Install the differential assembly into differen-
tial carrier in the reverse order of disassembly.
(4) Temporally tighten the side holder RH and
LH in differential carrier to install.
(1) Turn the drive pinion with ST for better fitting
of differential side bearing.
FLANGE WRENCH
DIFFERENTIALS
DI-00167
DI-00134
ST
DI-00169
Advertisement
Chapters
Table of Contents
