Subaru Legacy 2005 Service Manual page 2967

(4) Obtain the thickness of pinion height adjust-
ing washer to be inserted from the following for-
mula, and replace the temporarily installed
washer with this one.
NOTE:
Adjust it using the 1 — 3 washers.
T = To + N − 0.05 (mm)
T Thickness of pinion height adjusting
washer mm (in)
To Thickness of washer temporally
inserted mm (in)
N Clearance of thickness gauge mm (in)
Memo:
(Example of calculation)
To = 0.15 mm
N = 0.1 mm
T = 0.15 + 0.1 − 0.05 = 0.2 mm
Result: Thickness = 0.2 mm
Therefore use the pinion height adjusting washer of
part number 32295AA370.
Pinion height adjusting washer
Part No.
32295AA350
32295AA360
32295AA370
32295AA380
32295AA390
32295AA400
3) Install the selected pinion height adjusting wash-
er on drive pinion, and press the rear bearing cone
into position using ST.
ST 398177700 INSTALLER
ST
Rear Differential (VA-type)
Thickness mm (in)
0.150 (0.0059)
0.175 (0.0069)
0.200 (0.0079)
0.225 (0.0089)
0.250 (0.0098)
0.275 (0.0108)
DI-00085
DI-65
4) Insert the drive pinion into differential carrier, in-
stall the previously selected bearing preload adjust-
ing collar and washer.
(A)
(B)
(C)
(A) Drive pinion
(B) Bearing preload adjusting collar
(C) Bearing preload adjusting washer
(D) Differential carrier
5) Set ST and differential carrier to the press and
install the front bearing cone.
ST 399780104 WEIGHT
NOTE:
Set the carrier to the press until the companion
flange is installed.
6) Insert the collar, then install the pilot bearing.
(A) Pilot bearing
(B) Collar
DIFFERENTIALS
(D)
DI-00382
ST
DI-00383
(A)
(B)
DI-00389